series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 1 of 7 north america only features: models single output model max output power (w) output voltage range (v) output current (ma) input voltage (vac/hz) efficiency (%) amepr10 - 2629z 8 18 - 26 29 0 90 - 264 /47 - 63 8 3 amepr10 - 3329z 10 23 - 33 29 0 90 - 264 /47 - 63 8 3 amepr10 - 4224z 10 30 - 42 24 0 90 - 264 /47 - 63 8 6 note: all specifications in this datasheet are measured at an ambient temperature of 25c, humidity <75%, nominal input voltage and at rated output load unless otherwise specified. i nput specifications parameters conditions typical maximum units input current 90 vac , full load ? 0. 15 arms inrush current <2ms 115 vac , cold start ? 20 a 230 vac , cold start ? 40 leakage current ? 0.75 ma input dissipation no load 1 w output short 2 w power factor 115 vac , full load 0.9 0 230 vac , full load 0.9 0 input fuse 1 a/ 250v start - up time 115 vac , full load 2.0 sec . 230 vac , full load 1.0 se c. output specifications parameters conditions typical maximum units current accuracy 5 % line regulation l l to h l 3 % load regulation full output voltage range 3 % ripple & noise 1150 mv p - p output current ripple full load , 16.7 - 20 ms duration 550 ma p - p current overshoot l l to h l , full load at cold start, % of rated output current 1 0 % hold - up time (min) 0 m s minimum load voltage see models table above isolation specifications parameters conditions typical rated units tested i/o voltage iec61347 3750 v ac isolation resistance 500vdc >100m v ac isolation capacitance 100 pf general specifications parameters conditions typical maximum units switching frequency 135 khz ? accurate constant current output 5% ? class 2 power unit ? high efficiency: up to 86 % ? long life, high reliability ? active power factor correction ? ip20, suitable for indoor led lighting ? short circuit / open circuit protection ? 3 years limited warranty
series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 2 of 7 north america only over voltage protection amepr10 - 2629z 30 v amepr10 - 3329z 36 v amepr10 - 4224z 50 v short circuit protection continuous, hiccup mode short ci rcuit restart auto recovery open circuit protection continuous, hiccup mode operating temperature without derating - 20 to + 50 o c maximum case temperature 80 o c storage temperature - 30 to +90 o c temperature coefficient 0.05 % / o c cooling free air convection humidity 90 % rh case material plastic weight amepr10 - 2629z , amepr10 - 3329z 60 g amepr10 - 4224z 70 g dimensions (l x w x h ) amepr10 - 2629z , amepr10 - 3329z 3.46 x 1.54 x 0.91 inches 88.0 x 39.2 x 23.1 mm dimensions (l x w x h ) amepr10 - 4224z 3.68 x 1.76 x 1.08 inc hes 93.5 x 44.7 x 27.5 mm mtbf > 300 , 000 hrs (mil - hdbk - 217f at +25c) safety specifications parameters standards electromagnetic interfere nce en55015 / fcc part 15 , class b harmonic current emissions en61000 - 3 - 2, class b voltage fluctuations and flicker en61000 - 3 - 3 electrostatic discharge immunity en61000 - 4 - 2, 8kv air, 4kv contact, level 3, criteria a rf, electromagnetic field immunity en61000 - 4 - 3, test - rs level 3, criteria a electrical fast transient / burst immunity en61000 - 4 - 4, burst eft level 3, criteria a surge immunity en61000 - 4 - 5, line to neutral 2kv rf, conducted disturbance immunity en61000 - 4 - 6. test - cs level 3, criteria a power frequency magnetic field immunity en61000 - 4 - 8, test 3a/m, criteria a voltage dips, short interruptions immunity en61000 - 4 - 11, criteria b electromagnetic immunity requirements applies to lighting equipment en61547 pin definition application block diagram recommended wire gauge connection 20 - 24 ac l 20 - 24 ac n 14 - 26 led+ 14 - 26 led - ac 1 ac 2 led + led - ac 1 st led led led
series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 3 of 7 north america only dimensions amepr10 - 2629z & amepr10 - 3329z t o p v i e w 3 9 . 2 1 . 5 4 ? 6 . 0 ( 0 . 2 4 ) ? 3 . 0 ( 0 . 1 2 ) s i d e v i e w 1 8 8 . 0 3 . 4 6 2 3 . 1 0 . 9 1 s i d e v i e w 2 4 . 7 0 0 . 1 9 w i r e s s l o t 1 1 . 9 0 . 4 7
series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 4 of 7 north america only amepr10 - 4224z t o p v i e w 4 4 . 7 1 . 7 6 ? 6 . 0 ( 0 . 2 4 ) ? 3 . 0 ( 0 . 1 2 ) s i d e v i e w 1 9 3 . 5 3 . 6 8 2 7 . 5 1 . 0 8 s i d e v i e w 2 4 . 8 0 0 . 1 9 w i r e s s l o t 1 0 . 5 0 . 4 1
series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 5 of 7 north america only efficiency vs. input voltage & output load voltage amepr10 - 2629z amepr10 - 3329z amepr10 - 4224z 65.00% 70.00% 75.00% 80.00% 85.00% 90.00% 95.00% 18 20 22 24 26 efficiency output voltage(v) 115 vac 230 vac 65.00% 70.00% 75.00% 80.00% 85.00% 90.00% 95.00% 23 25 27 29 31 33 efficiency output voltage(v) 115 vac 230 vac 65.00% 70.00% 75.00% 80.00% 85.00% 90.00% 95.00% 30 33 36 39 42 efficiency output voltage(v) 115 vac 230 vac
series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 6 of 7 north america only pf vs. input voltage & output load voltage amepr10 - 2629z amepr10 - 3329z 0.000 0.300 0.600 0.900 1.200 18 20 22 24 26 pf output voltage(v) 115 vac 230 vac 0.000 0.300 0.600 0.900 1.200 23 25 27 29 31 33 pf output voltage(v) 115 vac 230 vac
series am epr1 0 - z up to 29 0 ma | a c - dc led driver www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052.1e r 2 7 of 7 north america only amepr10 - 4224z note: 1. datasheets are updated as needed and as such, specifications are subject to change without notice. once printed or downloaded, datasheets are no longer controlled by aimtec; refer to www.aimtec.com for the most current product specifications. 2. product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. mechanical drawings and specifications are for reference only. 4 . all specifications are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5 . aimtec may not hav e conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. cas numbers and other limited information are considered proprietary a nd may not be available for release. 6 . this product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control s ystems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this da tasheet . 7 . warranty is in accordance with aimtecs standard terms of sale available at www.aimtec.com . 0.000 0.300 0.600 0.900 1.200 30 33 36 39 42 pf output voltage(v) 115vac 230vac
|
